With the continuous development of chemical
and pharmaceutical industries, environmental pollution is put on the agenda
earlier. As an manufacturer of which is the industrial water chiller, I can say
that except for corresponding to the environmental protection theme, Our LNEYA
circulating water chillers use environmentally friendly materials and
хладагенты，increasing the efficiency constantly.

Industrial chiller units lower the
condensing temperature in the conditions of evaporating temperature, and increase
the vaporization point and reduce the condensation temperature as much as
possible when meeting the requirement of safety and manufacture, ensuring the
cooling water efficiency and enlarging the change of cooling tower.

I should tell you that for the sake of
ensuring the industrial water chiller to operate safely, the power dissipation
of a number of cold energies is smaller. It should consider the operating
situations of the water pump and cooling tower comprehensively while taking
this method into effect.

To prevent and reduce the pipe scaling of
industrial water chiller is for enhancing the heat transfer efficiency of the
condenser and evaporator. If the make-up water is treated badly, calcium
carbonate and magnesium carbonate produced by calcium bicarbonate and magnesium
bicarbonate through heating will precipitate on the pipes, decreasing the
heat-conducting property to have an impact on the heat exchange efficiency of
condenser and evaporator and increase the electric charge by a large margin for
chiller’s operation. Apart from using water treatment technology, that you can
apply the equipment for cleaning the pipes regularly, which can save the
electric quantity and at the same time level up cooling-water machine’s effect.

When centrifugal refrigeration machine’s
compressor is adjusted by the frequency converter of industrial water chiller
on account of revolving speed, the pressure will be raised as low-tension
refrigerant goes through hydroextractor. The faster the rotational speed is,
the higher the pressure is. In actual operation, the equipment works without a
full load. The centrifugal machine with fixed revolving speed operating in
small load will waste the energy.

When mastering the four points mentioned
above, I am sure the working efficiency will be improved better. It is
necessary to follow these steps so as to protect the environment!